I have a test unit AP7131 which was powered down during downgrade process from WiNG5.2.11 to WiNG4.3
Downgrade was applied on secondary firmware.
Device currently boots on primary firmware and stays in boot mode (LED1 solid red).
Please advise how to reload operational firmware to this unit in boot mode if it is possible at all.
Console port output during boot:
BootOS (c) 2004-2012 Motorola Solutions, Inc. All rights reserved.
boot image at 0x00040000..good
data bus walking 1's......pass
address bus walking 1's...pass
ddr device test...........pass
clearing ram..............done
copying to ram............done
BootOS (c) 2004-2012 Motorola Solutions, Inc. All rights reserved.
AP71XX version 5.2.11.0-007R
initializing pci
achip:pcc:0x000000ff,prc:0x00000060,fc:0x00000000
pci init done
fpga_sensor_mode 255
hw_type=0, sku=2R/Exp, ps_status=POE, pwr_level=2(0xb), mode=3af, af=range, at=throughput, radio_slot=0x3
*** power-management: shutting down ethernet port GE2 ***
loading linux image 1
invalid kernel
AP7131 BootOS 5.2.11.0-007R (r140939)
FPGA firmware revision 3.27
NOR bootstrap version 3, checksum good
boot>
Thanks Roland
1 Replies
Hi Roland, You can try to load the fw using network from the boot prompt. If it doesn't help, the only other option you have is to load the image through the serial port. How to is attached. Please note this will take a few hours. If that doesn't help, you need to get a replacement from Brno and RMA this AP.