DataWedge Setting

// Expert user has replied.
E Eric Wong 3 years 7 months ago
2 3 0

Hi,
 
I found a configuration in the DataWedge Demonstration APP that when works with 2D barcode imager, it helps to read the desired bar code from a no. of bar codes that are printed close together as shown below.
 
However, this setting is not persistent, if I existed the DWDemo APP and trigger the scanning, this setting is gone. I tried to look for the corresponding settings from the 'DataWedge Settings' in order to configure this function in other profiles such as 'Launcher' & 'Profile0(default) but failed.
 
Would like to know if I can set this from 'DataWedge Settings'?
 
Thanks!
 
Please Register or Login to post a reply

3 Replies

E Eric Wong 5 years 6 months ago

Thank you very much, Andreas.

E Eric Wong 5 years 6 months ago

Thanks Andreas!

Would like to know the difference between 'Hardware Picklist' and 'Software Picklist' as selecting either one will also work.

Best regards

A Andreas Fauerbach 5 years 6 months ago

Hi,

This feature is called "picklist mode". You can enable it in the "Reader params" section of your DataWedge profile.
I recommend creating a dedicated profile for your app and configure it accordingly.
Please refer to the DataWedge documentation.

CONTACT
Can’t find what you’re looking for?
Get in touch